blob: 06bc2145cb7d5d3fb8ea3d2894e618451584bb1a [file] [log] [blame]
Network Working Group SNMPv2 Working Group
Request for Comments: 1901 J. Case
Category: Experimental SNMP Research, Inc.
K. McCloghrie
Cisco Systems, Inc.
M. Rose
Dover Beach Consulting, Inc.
S. Waldbusser
International Network Services
January 1996
Introduction to Community-based SNMPv2
Status of this Memo
This document specifies an Experimental protocol for the Internet
community. This memo does not specify an Internet standard of any
kind. Discussion and suggestions for improvement are requested.
Distribution of this memo is unlimited.
Table of Contents
1. Introduction ................................................ 1
2. Components of the SNMPv2 Framework .......................... 2
2.1 Structure of Management Information ........................ 2
2.2 Textual Conventions ........................................ 3
2.3 Conformance Statements ..................................... 3
2.4 Protocol Operations ........................................ 3
2.5 Transport Mappings ......................................... 4
2.6 Protocol Instrumentation ................................... 4
3. The Community-based Administrative Framework ................ 4
4. Security Considerations ..................................... 5
5. Editor's Address ............................................ 6
6. Acknowledgements ............................................ 6
7. References .................................................. 7
1. Introduction
The purpose of this document is to define the Community-based
Administrative Framework for the SNMP version 2 framework (SNMPv2).
The SNMPv2 framework is fully described in [1-6]. This framework is
derived from the original Internet-standard Network Management
Framework (SNMPv1), which consists of these three documents:
STD 16, RFC 1155 [7] which defines the Structure of Management
Information (SMI), the mechanisms used for describing and naming
objects for the purpose of management.
SNMPv2 Working Group Experimental [Page 1]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
STD 16, RFC 1212 [8] which defines a more concise description
mechanism, which is wholly consistent with the SMI.
STD 15, RFC 1157 [9] which defines the Simple Network Management
Protocol (SNMP), the protocol used for network access to managed
objects.
For information on coexistence between SNMPv1 and SNMPv2, consult
[10].
2. Components of the SNMPv2 Framework
A management system contains: several (potentially many) nodes, each
with a processing entity, termed an agent, which has access to
management instrumentation; at least one management station; and, a
management protocol, used to convey management information between
the agents and management stations. Operations of the protocol are
carried out under an administrative framework which defines
authentication, authorization, access control, and privacy policies.
Management stations execute management applications which monitor and
control managed elements. Managed elements are devices such as
hosts, routers, terminal servers, etc., which are monitored and
controlled via access to their management information.
2.1. Structure of Management Information
Management information is viewed as a collection of managed objects,
residing in a virtual information store, termed the Management
Information Base (MIB). Collections of related objects are defined
in MIB modules. These modules are written using a subset of OSI's
Abstract Syntax Notation One (ASN.1) [11]. It is the purpose of the
Structure of Management Information for SNMPv2 document [1] to define
that subset.
The SMI is divided into three parts: module definitions, object
definitions, and, trap definitions.
(1) Module definitions are used when describing information modules.
An ASN.1 macro, MODULE-IDENTITY, is used to concisely convey the
semantics of an information module.
(2) Object definitions are used when describing managed objects. An
ASN.1 macro, OBJECT-TYPE, is used to concisely convey the syntax
and semantics of a managed object.
(3) Notification definitions are used when describing unsolicited
transmissions of management information. An ASN.1 macro,
SNMPv2 Working Group Experimental [Page 2]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
NOTIFICATION-TYPE, is used to concisely convey the syntax and
semantics of a notification.
2.2. Textual Conventions
When designing a MIB module, it is often useful to define new types
similar to those defined in the SMI. In comparison to a type defined
in the SMI, each of these new types has a different name, a similar
syntax, but a more precise semantics. These newly defined types are
termed textual conventions, and are used for the convenience of
humans reading the MIB module. It is the purpose of the Textual
Conventions for SNMPv2 document [2] to define the initial set of
textual conventions available to all MIB modules.
Objects defined using a textual convention are always encoded by
means of the rules that define their primitive type. However,
textual conventions often have special semantics associated with
them. As such, an ASN.1 macro, TEXTUAL-CONVENTION, is used to
concisely convey the syntax and semantics of a textual convention.
2.3. Conformance Statements
It may be useful to define the acceptable lower-bounds of
implementation, along with the actual level of implementation
achieved. It is the purpose of the Conformance Statements for SNMPv2
document [3] to define the notation used for these purposes. There
are two kinds of notations:
(1) Compliance statements are used when describing requirements for
agents with respect to object definitions. An ASN.1 macro,
MODULE-COMPLIANCE, is used to concisely convey such requirements.
(2) Capability statements are used when describing capabilities of
agents with respect to object definitions. An ASN.1 macro, AGENT-
CAPABILITIES, is used to concisely convey such capabilities.
Finally, collections of related objects are grouped together to form
a unit of conformance. An ASN.1 macro, OBJECT-GROUP, is used to
concisely convey the syntax and semantics of a group.
2.4. Protocol Operations
The management protocol provides for the exchange of messages which
convey management information between the agents and the management
stations. The form of these messages is a message "wrapper" which
encapsulates a Protocol Data Unit (PDU).
SNMPv2 Working Group Experimental [Page 3]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
It is the purpose of the Protocol Operations for SNMPv2 document [4]
to define the operations of the protocol with respect to the sending
and receiving of the PDUs.
2.5. Transport Mappings
The management protocol, version 2 of the Simple Network Management
Protocol, may be used over a variety of protocol suites. It is the
purpose of the Transport Mappings for SNMPv2 document [5] to define
how the SNMPv2 maps onto an initial set of transport domains. Other
mappings may be defined in the future.
Although several mappings are defined, the mapping onto UDP is the
preferred mapping. As such, to provide for the greatest level of
interoperability, systems which choose to deploy other mappings
should also provide for proxy service to the UDP mapping.
2.6. Protocol Instrumentation
It is the purpose of the Management Information Base for SNMPv2
document [6] to define managed objects which describe the behavior of
a SNMPv2 entity.
3. The Community-based Administrative Framework
It is the purpose of an administrative framework to define an
infrastructure through which effective management can be realized in
a variety of configurations and environments. Specified as a part
of, or as extensions of, an administrative framework are security
mechanisms used to achieve an administratively-defined level of
security for protocol interactions.
The administrative framework for SNMPv2 identified in this document
is the same framework as was defined for SNMPv1 [9]. This
administrative framework associates each message with a "community"
as defined in [9]. Use of this administrative framework with SNMP
Version 2 is commonly known as "Community-based SNMPv2 (SNMPv2C)."
Specifically, Section 3.2.5 of [9] defines the concept of a
community, and Section 4.1 of [9] defines the Elements of Procedure
for generating and receiving messages. The following updates apply:
(1) The types of access defined in Section 3.2.5 of [9] are updated
by [1].
(2) The Elements of Procedure defined in Section 4.1 of [9] are
updated with the additional requirement of incrementing the
relevant statistics counter as defined in [6].
SNMPv2 Working Group Experimental [Page 4]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
(3) The requirement in the Elements of Procedure in Section 4.1 of
[9] that the "the source transport address that a response
message is sent from shall be identical to the destination
transport address that the original request message was sent to"
is deleted, i.e., the source transport address of a response
message can be any transport address belonging to the agent.
The form of a message is also taken from [9], with the exception that
a new version number is used in the message "wrapper". Use of a new
version number is necessary because of SNMPv2's new PDU types [4],
error codes [4], etc. With this one change, the wrapper becomes:
COMMUNITY-BASED-SNMPv2 DEFINITIONS ::= BEGIN
-- top-level message
Message ::=
SEQUENCE {
version
INTEGER {
version(1) -- modified from RFC 1157
},
community -- community name
OCTET STRING,
data -- PDUs as defined in [4]
ANY
}
}
END
Note that with this administrative framework, the
'authorizationError(16)' value defined for the error-status component
of an SNMPv2 PDU [4] is unused. It may, however, be used with future
administrative frameworks.
4. Security Considerations
Security issues are not discussed in this memo.
SNMPv2 Working Group Experimental [Page 5]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
5. Editor's Address
Keith McCloghrie
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
US
Phone: +1 408 526 5260
EMail: kzm@cisco.com
6. Acknowledgements
This document is the result of significant work by the four major
contributors:
Jeffrey D. Case (SNMP Research, case@snmp.com)
Keith McCloghrie (Cisco Systems, kzm@cisco.com)
Marshall T. Rose (Dover Beach Consulting, mrose@dbc.mtview.ca.us)
Steven Waldbusser (International Network Services, stevew@uni.ins.com)
In addition, the contributions of the SNMPv2 Working Group are
acknowledged. In particular, a special thanks is extended for the
contributions of:
Alexander I. Alten (Novell)
Dave Arneson (Cabletron)
Uri Blumenthal (IBM)
Doug Book (Chipcom)
Kim Curran (Bell-Northern Research)
Jim Galvin (Trusted Information Systems)
Maria Greene (Ascom Timeplex)
Iain Hanson (Digital)
Dave Harrington (Cabletron)
Nguyen Hien (IBM)
Jeff Johnson (Cisco Systems)
Michael Kornegay (Object Quest)
Deirdre Kostick (AT&T Bell Labs)
David Levi (SNMP Research)
Daniel Mahoney (Cabletron)
Bob Natale (ACE*COMM)
Brian O'Keefe (Hewlett Packard)
Andrew Pearson (SNMP Research)
Dave Perkins (Peer Networks)
Randy Presuhn (Peer Networks)
Aleksey Romanov (Quality Quorum)
Shawn Routhier (Epilogue)
Jon Saperia (BGS Systems)
SNMPv2 Working Group Experimental [Page 6]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
Bob Stewart (Cisco Systems, bstewart@cisco.com), chair
Kaj Tesink (Bellcore)
Glenn Waters (Bell-Northern Research)
Bert Wijnen (IBM)
7. References
[1] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Structure of Management Information for Version 2
of the Simple Network Management Protocol (SNMPv2)", RFC 1902,
January 1996.
[2] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Textual Conventions for Version 2 of the Simple
Network Management Protocol (SNMPv2)", RFC 1903, January 1996.
[3] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Conformance Statements for Version 2 of the Simple
Network Management Protocol (SNMPv2)", RFC 1904, January 1996.
[4] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Protocol Operations for Version 2 of the Simple
Network Management Protocol (SNMPv2)", RFC 1905, January 1996.
[5] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Transport Mappings for Version 2 of the Simple
Network Management Protocol (SNMPv2)", RFC 1906, January 1996.
[6] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Management Information Base for Version 2 of the
Simple Network Management Protocol (SNMPv2)", RFC 1907,
January 1996.
[7] Rose, M., and K. McCloghrie, "Structure and Identification of
Management Information for TCP/IP-based internets", STD 16, RFC
1155, May 1990.
[8] Rose, M., and K. McCloghrie, "Concise MIB Definitions", STD 16,
RFC 1212, March 1991.
[9] Case, J., Fedor, M., Schoffstall, M., Davin, J., "Simple Network
Management Protocol", STD 15, RFC 1157, SNMP Research, Performance
Systems International, MIT Laboratory for Computer Science, May
1990.
SNMPv2 Working Group Experimental [Page 7]
RFC 1901 Introduction to Community-based SNMPv2 January 1996
[10] SNMPv2 Working Group, Case, J., McCloghrie, K., Rose, M., and
S. Waldbusser, "Coexistence between Version 1 and Version 2 of the
Internet-standard Network Management Framework", RFC 1908,
January 1996.
[11] Information processing systems - Open Systems Interconnection -
Specification of Abstract Syntax Notation One (ASN.1),
International Organization for Standardization. International
Standard 8824, (December, 1987).
SNMPv2 Working Group Experimental [Page 8]