| Overview |
| -------- |
| The T4240QDS is a high-performance computing evaluation, development and test |
| platform supporting the T4240 QorIQ™ Power Architecture™ processor. T4240QDS is |
| optimized to support the high-bandwidth DDR3 memory ports, as well as the |
| highly-configurable SerDes ports. The system is lead-free and RoHS-compliant. |
| |
| Board Features |
| SERDES Connections |
| 32 lanes grouped into four 8-lane banks |
| Two “front side” banks dedicated to Ethernet |
| - High-speed crosspoint switch fabric on selected lanes |
| - Two PCI Express slots with side-band connector supporting |
| - SGMII |
| - XAUI |
| - HiGig |
| - I-pass connectors allow board-to-board and loopback support |
| Two “back side” banks dedicated to other protocols |
| - High-speed crosspoint switch fabric on all lanes |
| - Four PCI Express slots with side-band connector supporting |
| - PCI Express 3.0 |
| - SATA 2.0 |
| - SRIO 2.0 |
| - Supports 4X Aurora debug with two connectors |
| DDR Controllers |
| Three independant 64-bit DDR3 controllers |
| Supports rates of 1866 up to 2133 MHz data-rate |
| Supports two DDR3/DDR3LP UDIMM/RDIMMs per controller |
| DDR power supplies 1.5V to all devices with automatic tracking of VTT. |
| Power software-switchable to 1.35V if software detects all DDR3LP devices. |
| MT9JSF25672AZ-2G1KZESZF has been tested at 1333, 1600, 1867, 2000 and |
| 2133MT/s speeds. For 1867MT/s and above, read-to-write turnaround time |
| increases by 1 clock. |
| |
| IFC/Local Bus |
| NAND flash: 8-bit, async or sync, up to 2GB. |
| NOR: 16-bit, Address/Data Multiplexed (ADM), up to 128 MB |
| NOR: 8-bit or 16-bit, non-multiplexed, up to 512MB |
| - NOR devices support 16 virtual banks |
| GASIC: Minimal target within Qixis FPGA |
| PromJET rapid memory download support |
| Address demultiplexing handled within FPGA. |
| - Flexible demux allows 8 or 16 bit evaluation. |
| IFC Debug/Development card |
| - Support for 32-bit devices |
| Ethernet |
| Support two on-board RGMII 10/100/1G ethernet ports. |
| SGMII and XAUI support via SERDES block (see above). |
| 1588 support via Symmetricom board. |
| QIXIS System Logic FPGA |
| Manages system power and reset sequencing |
| Manages DUT, board, clock, etc. configuration for dynamic shmoo |
| Collects V-I-T data in background for code/power profiling. |
| Supports legacy TMT test features (POSt, IRS, SYSCLK-synchronous assertion) |
| General fault monitoring and logging |
| Runs from ATX “hot” power rails allowing operation while system is off. |
| Clocks |
| System and DDR clock (SYSCLK, “DDRCLK”) |
| - Switch selectable to one of 16 common settings in the interval 33MHz-166MHz. |
| - Software selectable in 1MHz increments from 1-200MHz. |
| SERDES clocks |
| - Provides clocks to all SerDes blocks and slots |
| - 100, 125 and 156.25 MHz |
| Power Supplies |
| Dedicated regulators for VDD |
| - Adjustable from (0.7V to 1.3V at 80A |
| - Regulators can be controlled by VID and/or software |
| Dedicated regulator for GVDD_PL: 1.35/1.5V at 22A |
| - VTT/MVREF automatically track operating voltage |
| Dedicated regulators/filters for AVDD supplies |
| Dedicated regulators for other supplies: OVDD, BVDD, DVDD, LVDD, POVDD, etc. |
| USB |
| Supports two USB 2.0 ports with integrated PHYs |
| - One type A, one type micro-AB with 1.0A power per port. |
| Other IO |
| eSDHC/MMC |
| - SDHC card slot |
| eSPI port |
| - High-speed serial flash |
| Two Serial port |
| Four I2C ports |
| |
| Memory map |
| ---------- |
| The addresses in brackets are physical addresses. |
| |
| 0x0_0000_0000 (0x0_0000_0000) - 0x0_7fff_ffff 2GB DDR (more than 2GB is initialized but not mapped under with TLB) |
| 0x0_8000_0000 (0xc_0000_0000) - 0x0_dfff_ffff 1.5GB PCIE memory |
| 0x0_f000_0000 (0xf_0000_0000) - 0x0_f03f_ffff 4MB DCSR |
| 0x0_f400_0000 (0xf_f400_0000) - 0x0_f5ff_ffff 32MB BMan |
| 0x0_f600_0000 (0xf_f600_0000) - 0x0_f7ff_ffff 32MB QMan |
| 0x0_f800_0000 (0xf_f800_0000) - 0x0_f803_ffff 256KB PCIE IO |
| 0x0_e000_0000 (0xf_e000_0000) - 0x0_efff_ffff 256MB NOR flash |
| 0x0_fe00_0000 (0xf_fe00_0000) - 0x0_feff_ffff 16MB CCSR |
| 0x0_ffdf_0000 (0xf_ffdf_0000) - 0x0_ffdf_03ff 4KB QIXIS |
| 0x0_ffff_f000 (0x0_7fff_fff0) - 0x0_ffff_ffff 4KB Boot page translation for secondary cores |
| |
| The physical address of the last (boot page translation) varies with the actual DDR size. |
