| /* |
| * Compex's MyLoader specific definitions |
| * |
| * Copyright (C) 2006-2008 Gabor Juhos <juhosg@openwrt.org> |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License version 2 as published |
| * by the Free Software Foundation. |
| * |
| */ |
| |
| #ifndef _MYLOADER_H_ |
| #define _MYLOADER_H_ |
| |
| /* Myloader specific magic numbers */ |
| #define MYLO_MAGIC_SYS_PARAMS 0x20021107 |
| #define MYLO_MAGIC_PARTITIONS 0x20021103 |
| #define MYLO_MAGIC_BOARD_PARAMS 0x20021103 |
| |
| /* Vendor ID's (seems to be same as the PCI vendor ID's) */ |
| #define VENID_COMPEX 0x11F6 |
| |
| /* Devices based on the ADM5120 */ |
| #define DEVID_COMPEX_NP27G 0x0078 |
| #define DEVID_COMPEX_NP28G 0x044C |
| #define DEVID_COMPEX_NP28GHS 0x044E |
| #define DEVID_COMPEX_WP54Gv1C 0x0514 |
| #define DEVID_COMPEX_WP54G 0x0515 |
| #define DEVID_COMPEX_WP54AG 0x0546 |
| #define DEVID_COMPEX_WPP54AG 0x0550 |
| #define DEVID_COMPEX_WPP54G 0x0555 |
| |
| /* Devices based on the Atheros AR2317 */ |
| #define DEVID_COMPEX_NP25G 0x05E6 |
| #define DEVID_COMPEX_WPE53G 0x05DC |
| |
| /* Devices based on the Atheros AR71xx */ |
| #define DEVID_COMPEX_WP543 0x0640 |
| #define DEVID_COMPEX_WPE72 0x0672 |
| |
| /* Devices based on the IXP422 */ |
| #define DEVID_COMPEX_WP18 0x047E |
| #define DEVID_COMPEX_NP18A 0x0489 |
| |
| /* Other devices */ |
| #define DEVID_COMPEX_NP26G8M 0x03E8 |
| #define DEVID_COMPEX_NP26G16M 0x03E9 |
| |
| struct mylo_partition { |
| uint16_t flags; /* partition flags */ |
| uint16_t type; /* type of the partition */ |
| uint32_t addr; /* relative address of the partition from the |
| flash start */ |
| uint32_t size; /* size of the partition in bytes */ |
| uint32_t param; /* if this is the active partition, the |
| MyLoader load code to this address */ |
| }; |
| |
| #define PARTITION_FLAG_ACTIVE 0x8000 /* this is the active partition, |
| * MyLoader loads firmware from here */ |
| #define PARTITION_FLAG_ISRAM 0x2000 /* FIXME: this is a RAM partition? */ |
| #define PARTIIION_FLAG_RAMLOAD 0x1000 /* FIXME: load this partition into the RAM? */ |
| #define PARTITION_FLAG_PRELOAD 0x0800 /* the partition data preloaded to RAM |
| * before decompression */ |
| #define PARTITION_FLAG_LZMA 0x0100 /* partition data compressed by LZMA */ |
| #define PARTITION_FLAG_HAVEHDR 0x0002 /* the partition data have a header */ |
| |
| #define PARTITION_TYPE_FREE 0 |
| #define PARTITION_TYPE_USED 1 |
| |
| #define MYLO_MAX_PARTITIONS 8 /* maximum number of partitions in the |
| partition table */ |
| |
| struct mylo_partition_table { |
| uint32_t magic; /* must be MYLO_MAGIC_PARTITIONS */ |
| uint32_t res0; /* unknown/unused */ |
| uint32_t res1; /* unknown/unused */ |
| uint32_t res2; /* unknown/unused */ |
| struct mylo_partition partitions[MYLO_MAX_PARTITIONS]; |
| }; |
| |
| struct mylo_partition_header { |
| uint32_t len; /* length of the partition data */ |
| uint32_t crc; /* CRC value of the partition data */ |
| }; |
| |
| struct mylo_system_params { |
| uint32_t magic; /* must be MYLO_MAGIC_SYS_PARAMS */ |
| uint32_t res0; |
| uint32_t res1; |
| uint32_t mylo_ver; |
| uint16_t vid; /* Vendor ID */ |
| uint16_t did; /* Device ID */ |
| uint16_t svid; /* Sub Vendor ID */ |
| uint16_t sdid; /* Sub Device ID */ |
| uint32_t rev; /* device revision */ |
| uint32_t fwhi; |
| uint32_t fwlo; |
| uint32_t tftp_addr; |
| uint32_t prog_start; |
| uint32_t flash_size; /* size of boot FLASH in bytes */ |
| uint32_t dram_size; /* size of onboard RAM in bytes */ |
| }; |
| |
| struct mylo_eth_addr { |
| uint8_t mac[6]; |
| uint8_t csum[2]; |
| }; |
| |
| #define MYLO_ETHADDR_COUNT 8 /* maximum number of ethernet address |
| in the board parameters */ |
| |
| struct mylo_board_params { |
| uint32_t magic; /* must be MYLO_MAGIC_BOARD_PARAMS */ |
| uint32_t res0; |
| uint32_t res1; |
| uint32_t res2; |
| struct mylo_eth_addr addr[MYLO_ETHADDR_COUNT]; |
| }; |
| |
| #endif /* _MYLOADER_H_*/ |