| /* |
| * SBC8641D Device Tree Source |
| * |
| * Copyright 2008 Wind River Systems Inc. |
| * |
| * Paul Gortmaker (see MAINTAINERS for contact information) |
| * |
| * Based largely on the mpc8641_hpcn.dts by Freescale Semiconductor Inc. |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License as published by the |
| * Free Software Foundation; either version 2 of the License, or (at your |
| * option) any later version. |
| */ |
| |
| /include/ "mpc8641si-pre.dtsi" |
| |
| / { |
| model = "SBC8641D"; |
| compatible = "wind,sbc8641"; |
| |
| memory { |
| device_type = "memory"; |
| reg = <0x00000000 0x20000000>; // 512M at 0x0 |
| }; |
| |
| lbc: localbus@f8005000 { |
| reg = <0xf8005000 0x1000>; |
| |
| ranges = <0 0 0xff000000 0x01000000 // 16MB Boot flash |
| 1 0 0xf0000000 0x00010000 // 64KB EEPROM |
| 2 0 0xf1000000 0x00100000 // EPLD (1MB) |
| 3 0 0xe0000000 0x04000000 // 64MB LB SDRAM (CS3) |
| 4 0 0xe4000000 0x04000000 // 64MB LB SDRAM (CS4) |
| 6 0 0xf4000000 0x00100000 // LCD display (1MB) |
| 7 0 0xe8000000 0x04000000>; // 64MB OneNAND |
| |
| flash@0,0 { |
| compatible = "cfi-flash"; |
| reg = <0 0 0x01000000>; |
| bank-width = <2>; |
| device-width = <2>; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| partition@0 { |
| label = "dtb"; |
| reg = <0x00000000 0x00100000>; |
| read-only; |
| }; |
| partition@300000 { |
| label = "kernel"; |
| reg = <0x00100000 0x00400000>; |
| read-only; |
| }; |
| partition@400000 { |
| label = "fs"; |
| reg = <0x00500000 0x00a00000>; |
| }; |
| partition@700000 { |
| label = "firmware"; |
| reg = <0x00f00000 0x00100000>; |
| read-only; |
| }; |
| }; |
| |
| epld@2,0 { |
| compatible = "wrs,epld-localbus"; |
| #address-cells = <2>; |
| #size-cells = <1>; |
| reg = <2 0 0x100000>; |
| ranges = <0 0 5 0 1 // User switches |
| 1 0 5 1 1 // Board ID/Rev |
| 3 0 5 3 1>; // LEDs |
| }; |
| }; |
| |
| soc: soc@f8000000 { |
| ranges = <0x00000000 0xf8000000 0x00100000>; |
| |
| enet0: ethernet@24000 { |
| tbi-handle = <&tbi0>; |
| phy-handle = <&phy0>; |
| phy-connection-type = "rgmii-id"; |
| }; |
| |
| mdio@24520 { |
| phy0: ethernet-phy@1f { |
| reg = <0x1f>; |
| }; |
| phy1: ethernet-phy@0 { |
| reg = <0>; |
| }; |
| phy2: ethernet-phy@1 { |
| reg = <1>; |
| }; |
| phy3: ethernet-phy@2 { |
| reg = <2>; |
| }; |
| tbi0: tbi-phy@11 { |
| reg = <0x11>; |
| device_type = "tbi-phy"; |
| }; |
| }; |
| |
| enet1: ethernet@25000 { |
| tbi-handle = <&tbi1>; |
| phy-handle = <&phy1>; |
| phy-connection-type = "rgmii-id"; |
| }; |
| |
| mdio@25520 { |
| tbi1: tbi-phy@11 { |
| reg = <0x11>; |
| device_type = "tbi-phy"; |
| }; |
| }; |
| |
| enet2: ethernet@26000 { |
| tbi-handle = <&tbi2>; |
| phy-handle = <&phy2>; |
| phy-connection-type = "rgmii-id"; |
| }; |
| |
| mdio@26520 { |
| tbi2: tbi-phy@11 { |
| reg = <0x11>; |
| device_type = "tbi-phy"; |
| }; |
| }; |
| |
| enet3: ethernet@27000 { |
| tbi-handle = <&tbi3>; |
| phy-handle = <&phy3>; |
| phy-connection-type = "rgmii-id"; |
| }; |
| |
| mdio@27520 { |
| tbi3: tbi-phy@11 { |
| reg = <0x11>; |
| device_type = "tbi-phy"; |
| }; |
| }; |
| }; |
| |
| pci0: pcie@f8008000 { |
| reg = <0xf8008000 0x1000>; |
| ranges = <0x02000000 0x0 0x80000000 0x80000000 0x0 0x20000000 |
| 0x01000000 0x0 0x00000000 0xe2000000 0x0 0x00100000>; |
| interrupt-map-mask = <0xff00 0 0 7>; |
| |
| pcie@0 { |
| ranges = <0x02000000 0x0 0x80000000 |
| 0x02000000 0x0 0x80000000 |
| 0x0 0x20000000 |
| |
| 0x01000000 0x0 0x00000000 |
| 0x01000000 0x0 0x00000000 |
| 0x0 0x00100000>; |
| }; |
| |
| }; |
| |
| pci1: pcie@f8009000 { |
| reg = <0xf8009000 0x1000>; |
| ranges = <0x02000000 0x0 0xa0000000 0xa0000000 0x0 0x20000000 |
| 0x01000000 0x0 0x00000000 0xe3000000 0x0 0x00100000>; |
| |
| pcie@0 { |
| ranges = <0x02000000 0x0 0xa0000000 |
| 0x02000000 0x0 0xa0000000 |
| 0x0 0x20000000 |
| |
| 0x01000000 0x0 0x00000000 |
| 0x01000000 0x0 0x00000000 |
| 0x0 0x00100000>; |
| }; |
| }; |
| }; |
| |
| /include/ "mpc8641si-post.dtsi" |