| /* |
| * Macintosh interrupts |
| * |
| * General design: |
| * In contrary to the Amiga and Atari platforms, the Mac hardware seems to |
| * exclusively use the autovector interrupts (the 'generic level0-level7' |
| * interrupts with exception vectors 0x19-0x1f). The following interrupt levels |
| * are used: |
| * 1 - VIA1 |
| * - slot 0: one second interrupt (CA2) |
| * - slot 1: VBlank (CA1) |
| * - slot 2: ADB data ready (SR full) |
| * - slot 3: ADB data (CB2) |
| * - slot 4: ADB clock (CB1) |
| * - slot 5: timer 2 |
| * - slot 6: timer 1 |
| * - slot 7: status of IRQ; signals 'any enabled int.' |
| * |
| * 2 - VIA2 or RBV |
| * - slot 0: SCSI DRQ (CA2) |
| * - slot 1: NUBUS IRQ (CA1) need to read port A to find which |
| * - slot 2: /EXP IRQ (only on IIci) |
| * - slot 3: SCSI IRQ (CB2) |
| * - slot 4: ASC IRQ (CB1) |
| * - slot 5: timer 2 (not on IIci) |
| * - slot 6: timer 1 (not on IIci) |
| * - slot 7: status of IRQ; signals 'any enabled int.' |
| * |
| * Levels 3-6 vary by machine type. For VIA or RBV Macintoshes: |
| * |
| * 3 - unused (?) |
| * |
| * 4 - SCC |
| * |
| * 5 - unused (?) |
| * [serial errors or special conditions seem to raise level 6 |
| * interrupts on some models (LC4xx?)] |
| * |
| * 6 - off switch (?) |
| * |
| * Machines with Quadra-like VIA hardware, except PSC and PMU machines, support |
| * an alternate interrupt mapping, as used by A/UX. It spreads ethernet and |
| * sound out to their own autovector IRQs and gives VIA1 a higher priority: |
| * |
| * 1 - unused (?) |
| * |
| * 3 - on-board SONIC |
| * |
| * 5 - Apple Sound Chip (ASC) |
| * |
| * 6 - VIA1 |
| * |
| * For OSS Macintoshes (IIfx only), we apply an interrupt mapping similar to |
| * the Quadra (A/UX) mapping: |
| * |
| * 1 - ISM IOP (ADB) |
| * |
| * 2 - SCSI |
| * |
| * 3 - NuBus |
| * |
| * 4 - SCC IOP |
| * |
| * 6 - VIA1 |
| * |
| * For PSC Macintoshes (660AV, 840AV): |
| * |
| * 3 - PSC level 3 |
| * - slot 0: MACE |
| * |
| * 4 - PSC level 4 |
| * - slot 1: SCC channel A interrupt |
| * - slot 2: SCC channel B interrupt |
| * - slot 3: MACE DMA |
| * |
| * 5 - PSC level 5 |
| * |
| * 6 - PSC level 6 |
| * |
| * Finally we have good 'ole level 7, the non-maskable interrupt: |
| * |
| * 7 - NMI (programmer's switch on the back of some Macs) |
| * Also RAM parity error on models which support it (IIc, IIfx?) |
| * |
| * The current interrupt logic looks something like this: |
| * |
| * - We install dispatchers for the autovector interrupts (1-7). These |
| * dispatchers are responsible for querying the hardware (the |
| * VIA/RBV/OSS/PSC chips) to determine the actual interrupt source. Using |
| * this information a machspec interrupt number is generated by placing the |
| * index of the interrupt hardware into the low three bits and the original |
| * autovector interrupt number in the upper 5 bits. The handlers for the |
| * resulting machspec interrupt are then called. |
| * |
| * - Nubus is a special case because its interrupts are hidden behind two |
| * layers of hardware. Nubus interrupts come in as index 1 on VIA #2, |
| * which translates to IRQ number 17. In this spot we install _another_ |
| * dispatcher. This dispatcher finds the interrupting slot number (9-F) and |
| * then forms a new machspec interrupt number as above with the slot number |
| * minus 9 in the low three bits and the pseudo-level 7 in the upper five |
| * bits. The handlers for this new machspec interrupt number are then |
| * called. This puts Nubus interrupts into the range 56-62. |
| * |
| * - The Baboon interrupts (used on some PowerBooks) are an even more special |
| * case. They're hidden behind the Nubus slot $C interrupt thus adding a |
| * third layer of indirection. Why oh why did the Apple engineers do that? |
| * |
| */ |
| |
| #include <linux/types.h> |
| #include <linux/kernel.h> |
| #include <linux/sched.h> |
| #include <linux/interrupt.h> |
| #include <linux/irq.h> |
| #include <linux/delay.h> |
| |
| #include <asm/irq.h> |
| #include <asm/macintosh.h> |
| #include <asm/macints.h> |
| #include <asm/mac_via.h> |
| #include <asm/mac_psc.h> |
| #include <asm/mac_oss.h> |
| #include <asm/mac_iop.h> |
| #include <asm/mac_baboon.h> |
| #include <asm/hwtest.h> |
| #include <asm/irq_regs.h> |
| |
| #define SHUTUP_SONIC |
| |
| /* |
| * console_loglevel determines NMI handler function |
| */ |
| |
| irqreturn_t mac_nmi_handler(int, void *); |
| irqreturn_t mac_debug_handler(int, void *); |
| |
| /* #define DEBUG_MACINTS */ |
| |
| static unsigned int mac_irq_startup(struct irq_data *); |
| static void mac_irq_shutdown(struct irq_data *); |
| |
| static struct irq_chip mac_irq_chip = { |
| .name = "mac", |
| .irq_enable = mac_irq_enable, |
| .irq_disable = mac_irq_disable, |
| .irq_startup = mac_irq_startup, |
| .irq_shutdown = mac_irq_shutdown, |
| }; |
| |
| void __init mac_init_IRQ(void) |
| { |
| #ifdef DEBUG_MACINTS |
| printk("mac_init_IRQ(): Setting things up...\n"); |
| #endif |
| m68k_setup_irq_controller(&mac_irq_chip, handle_simple_irq, IRQ_USER, |
| NUM_MAC_SOURCES - IRQ_USER); |
| /* Make sure the SONIC interrupt is cleared or things get ugly */ |
| #ifdef SHUTUP_SONIC |
| printk("Killing onboard sonic... "); |
| /* This address should hopefully be mapped already */ |
| if (hwreg_present((void*)(0x50f0a000))) { |
| *(long *)(0x50f0a014) = 0x7fffL; |
| *(long *)(0x50f0a010) = 0L; |
| } |
| printk("Done.\n"); |
| #endif /* SHUTUP_SONIC */ |
| |
| /* |
| * Now register the handlers for the master IRQ handlers |
| * at levels 1-7. Most of the work is done elsewhere. |
| */ |
| |
| if (oss_present) |
| oss_register_interrupts(); |
| else |
| via_register_interrupts(); |
| if (psc) |
| psc_register_interrupts(); |
| if (baboon_present) |
| baboon_register_interrupts(); |
| iop_register_interrupts(); |
| if (request_irq(IRQ_AUTO_7, mac_nmi_handler, 0, "NMI", |
| mac_nmi_handler)) |
| pr_err("Couldn't register NMI\n"); |
| #ifdef DEBUG_MACINTS |
| printk("mac_init_IRQ(): Done!\n"); |
| #endif |
| } |
| |
| /* |
| * mac_irq_enable - enable an interrupt source |
| * mac_irq_disable - disable an interrupt source |
| * |
| * These routines are just dispatchers to the VIA/OSS/PSC routines. |
| */ |
| |
| void mac_irq_enable(struct irq_data *data) |
| { |
| int irq = data->irq; |
| int irq_src = IRQ_SRC(irq); |
| |
| switch(irq_src) { |
| case 1: |
| case 2: |
| case 7: |
| if (oss_present) |
| oss_irq_enable(irq); |
| else |
| via_irq_enable(irq); |
| break; |
| case 3: |
| case 4: |
| case 5: |
| case 6: |
| if (psc) |
| psc_irq_enable(irq); |
| else if (oss_present) |
| oss_irq_enable(irq); |
| break; |
| case 8: |
| if (baboon_present) |
| baboon_irq_enable(irq); |
| break; |
| } |
| } |
| |
| void mac_irq_disable(struct irq_data *data) |
| { |
| int irq = data->irq; |
| int irq_src = IRQ_SRC(irq); |
| |
| switch(irq_src) { |
| case 1: |
| case 2: |
| case 7: |
| if (oss_present) |
| oss_irq_disable(irq); |
| else |
| via_irq_disable(irq); |
| break; |
| case 3: |
| case 4: |
| case 5: |
| case 6: |
| if (psc) |
| psc_irq_disable(irq); |
| else if (oss_present) |
| oss_irq_disable(irq); |
| break; |
| case 8: |
| if (baboon_present) |
| baboon_irq_disable(irq); |
| break; |
| } |
| } |
| |
| static unsigned int mac_irq_startup(struct irq_data *data) |
| { |
| int irq = data->irq; |
| |
| if (IRQ_SRC(irq) == 7 && !oss_present) |
| via_nubus_irq_startup(irq); |
| else |
| mac_irq_enable(data); |
| |
| return 0; |
| } |
| |
| static void mac_irq_shutdown(struct irq_data *data) |
| { |
| int irq = data->irq; |
| |
| if (IRQ_SRC(irq) == 7 && !oss_present) |
| via_nubus_irq_shutdown(irq); |
| else |
| mac_irq_disable(data); |
| } |
| |
| static int num_debug[8]; |
| |
| irqreturn_t mac_debug_handler(int irq, void *dev_id) |
| { |
| if (num_debug[irq] < 10) { |
| printk("DEBUG: Unexpected IRQ %d\n", irq); |
| num_debug[irq]++; |
| } |
| return IRQ_HANDLED; |
| } |
| |
| static int in_nmi; |
| static volatile int nmi_hold; |
| |
| irqreturn_t mac_nmi_handler(int irq, void *dev_id) |
| { |
| int i; |
| /* |
| * generate debug output on NMI switch if 'debug' kernel option given |
| * (only works with Penguin!) |
| */ |
| |
| in_nmi++; |
| for (i=0; i<100; i++) |
| udelay(1000); |
| |
| if (in_nmi == 1) { |
| nmi_hold = 1; |
| printk("... pausing, press NMI to resume ..."); |
| } else { |
| printk(" ok!\n"); |
| nmi_hold = 0; |
| } |
| |
| barrier(); |
| |
| while (nmi_hold == 1) |
| udelay(1000); |
| |
| if (console_loglevel >= 8) { |
| #if 0 |
| struct pt_regs *fp = get_irq_regs(); |
| show_state(); |
| printk("PC: %08lx\nSR: %04x SP: %p\n", fp->pc, fp->sr, fp); |
| printk("d0: %08lx d1: %08lx d2: %08lx d3: %08lx\n", |
| fp->d0, fp->d1, fp->d2, fp->d3); |
| printk("d4: %08lx d5: %08lx a0: %08lx a1: %08lx\n", |
| fp->d4, fp->d5, fp->a0, fp->a1); |
| |
| if (STACK_MAGIC != *(unsigned long *)current->kernel_stack_page) |
| printk("Corrupted stack page\n"); |
| printk("Process %s (pid: %d, stackpage=%08lx)\n", |
| current->comm, current->pid, current->kernel_stack_page); |
| if (intr_count == 1) |
| dump_stack((struct frame *)fp); |
| #else |
| /* printk("NMI "); */ |
| #endif |
| } |
| in_nmi--; |
| return IRQ_HANDLED; |
| } |