| #ifndef LINUX_BCMA_REGS_H_ |
| #define LINUX_BCMA_REGS_H_ |
| |
| /* Some single registers are shared between many cores */ |
| /* BCMA_CLKCTLST: ChipCommon (rev >= 20), PCIe, 80211 */ |
| #define BCMA_CLKCTLST 0x01E0 /* Clock control and status */ |
| #define BCMA_CLKCTLST_FORCEALP 0x00000001 /* Force ALP request */ |
| #define BCMA_CLKCTLST_FORCEHT 0x00000002 /* Force HT request */ |
| #define BCMA_CLKCTLST_FORCEILP 0x00000004 /* Force ILP request */ |
| #define BCMA_CLKCTLST_HAVEALPREQ 0x00000008 /* ALP available request */ |
| #define BCMA_CLKCTLST_HAVEHTREQ 0x00000010 /* HT available request */ |
| #define BCMA_CLKCTLST_HWCROFF 0x00000020 /* Force HW clock request off */ |
| #define BCMA_CLKCTLST_EXTRESREQ 0x00000700 /* Mask of external resource requests */ |
| #define BCMA_CLKCTLST_EXTRESREQ_SHIFT 8 |
| #define BCMA_CLKCTLST_HAVEALP 0x00010000 /* ALP available */ |
| #define BCMA_CLKCTLST_HAVEHT 0x00020000 /* HT available */ |
| #define BCMA_CLKCTLST_BP_ON_ALP 0x00040000 /* RO: running on ALP clock */ |
| #define BCMA_CLKCTLST_BP_ON_HT 0x00080000 /* RO: running on HT clock */ |
| #define BCMA_CLKCTLST_EXTRESST 0x07000000 /* Mask of external resource status */ |
| #define BCMA_CLKCTLST_EXTRESST_SHIFT 24 |
| /* Is there any BCM4328 on BCMA bus? */ |
| #define BCMA_CLKCTLST_4328A0_HAVEHT 0x00010000 /* 4328a0 has reversed bits */ |
| #define BCMA_CLKCTLST_4328A0_HAVEALP 0x00020000 /* 4328a0 has reversed bits */ |
| |
| /* Agent registers (common for every core) */ |
| #define BCMA_IOCTL 0x0408 /* IO control */ |
| #define BCMA_IOCTL_CLK 0x0001 |
| #define BCMA_IOCTL_FGC 0x0002 |
| #define BCMA_IOCTL_CORE_BITS 0x3FFC |
| #define BCMA_IOCTL_PME_EN 0x4000 |
| #define BCMA_IOCTL_BIST_EN 0x8000 |
| #define BCMA_IOST 0x0500 /* IO status */ |
| #define BCMA_IOST_CORE_BITS 0x0FFF |
| #define BCMA_IOST_DMA64 0x1000 |
| #define BCMA_IOST_GATED_CLK 0x2000 |
| #define BCMA_IOST_BIST_ERROR 0x4000 |
| #define BCMA_IOST_BIST_DONE 0x8000 |
| #define BCMA_RESET_CTL 0x0800 |
| #define BCMA_RESET_CTL_RESET 0x0001 |
| #define BCMA_RESET_ST 0x0804 |
| |
| #define BCMA_NS_ROM_IOST_BOOT_DEV_MASK 0x0003 |
| #define BCMA_NS_ROM_IOST_BOOT_DEV_NOR 0x0000 |
| #define BCMA_NS_ROM_IOST_BOOT_DEV_NAND 0x0001 |
| #define BCMA_NS_ROM_IOST_BOOT_DEV_ROM 0x0002 |
| |
| /* BCMA PCI config space registers. */ |
| #define BCMA_PCI_PMCSR 0x44 |
| #define BCMA_PCI_PE 0x100 |
| #define BCMA_PCI_BAR0_WIN 0x80 /* Backplane address space 0 */ |
| #define BCMA_PCI_BAR1_WIN 0x84 /* Backplane address space 1 */ |
| #define BCMA_PCI_SPROMCTL 0x88 /* SPROM control */ |
| #define BCMA_PCI_SPROMCTL_WE 0x10 /* SPROM write enable */ |
| #define BCMA_PCI_BAR1_CONTROL 0x8c /* Address space 1 burst control */ |
| #define BCMA_PCI_IRQS 0x90 /* PCI interrupts */ |
| #define BCMA_PCI_IRQMASK 0x94 /* PCI IRQ control and mask (pcirev >= 6 only) */ |
| #define BCMA_PCI_BACKPLANE_IRQS 0x98 /* Backplane Interrupts */ |
| #define BCMA_PCI_BAR0_WIN2 0xAC |
| #define BCMA_PCI_GPIO_IN 0xB0 /* GPIO Input (pcirev >= 3 only) */ |
| #define BCMA_PCI_GPIO_OUT 0xB4 /* GPIO Output (pcirev >= 3 only) */ |
| #define BCMA_PCI_GPIO_OUT_ENABLE 0xB8 /* GPIO Output Enable/Disable (pcirev >= 3 only) */ |
| #define BCMA_PCI_GPIO_SCS 0x10 /* PCI config space bit 4 for 4306c0 slow clock source */ |
| #define BCMA_PCI_GPIO_HWRAD 0x20 /* PCI config space GPIO 13 for hw radio disable */ |
| #define BCMA_PCI_GPIO_XTAL 0x40 /* PCI config space GPIO 14 for Xtal powerup */ |
| #define BCMA_PCI_GPIO_PLL 0x80 /* PCI config space GPIO 15 for PLL powerdown */ |
| |
| #define BCMA_PCIE2_BAR0_WIN2 0x70 |
| |
| /* SiliconBackplane Address Map. |
| * All regions may not exist on all chips. |
| */ |
| #define BCMA_SOC_SDRAM_BASE 0x00000000U /* Physical SDRAM */ |
| #define BCMA_SOC_PCI_MEM 0x08000000U /* Host Mode sb2pcitranslation0 (64 MB) */ |
| #define BCMA_SOC_PCI_MEM_SZ (64 * 1024 * 1024) |
| #define BCMA_SOC_PCI_CFG 0x0c000000U /* Host Mode sb2pcitranslation1 (64 MB) */ |
| #define BCMA_SOC_SDRAM_SWAPPED 0x10000000U /* Byteswapped Physical SDRAM */ |
| #define BCMA_SOC_SDRAM_R2 0x80000000U /* Region 2 for sdram (512 MB) */ |
| |
| |
| #define BCMA_SOC_PCI_DMA 0x40000000U /* Client Mode sb2pcitranslation2 (1 GB) */ |
| #define BCMA_SOC_PCI_DMA2 0x80000000U /* Client Mode sb2pcitranslation2 (1 GB) */ |
| #define BCMA_SOC_PCI_DMA_SZ 0x40000000U /* Client Mode sb2pcitranslation2 size in bytes */ |
| #define BCMA_SOC_PCIE_DMA_L32 0x00000000U /* PCIE Client Mode sb2pcitranslation2 |
| * (2 ZettaBytes), low 32 bits |
| */ |
| #define BCMA_SOC_PCIE_DMA_H32 0x80000000U /* PCIE Client Mode sb2pcitranslation2 |
| * (2 ZettaBytes), high 32 bits |
| */ |
| |
| #define BCMA_SOC_PCI1_MEM 0x40000000U /* Host Mode sb2pcitranslation0 (64 MB) */ |
| #define BCMA_SOC_PCI1_CFG 0x44000000U /* Host Mode sb2pcitranslation1 (64 MB) */ |
| #define BCMA_SOC_PCIE1_DMA_H32 0xc0000000U /* PCIE Client Mode sb2pcitranslation2 |
| * (2 ZettaBytes), high 32 bits |
| */ |
| |
| #define BCMA_SOC_FLASH1 0x1fc00000 /* MIPS Flash Region 1 */ |
| #define BCMA_SOC_FLASH1_SZ 0x00400000 /* MIPS Size of Flash Region 1 */ |
| #define BCMA_SOC_FLASH2 0x1c000000 /* Flash Region 2 (region 1 shadowed here) */ |
| #define BCMA_SOC_FLASH2_SZ 0x02000000 /* Size of Flash Region 2 */ |
| |
| #endif /* LINUX_BCMA_REGS_H_ */ |
