| Generic vcpu interface |
| ==================================== |
| |
| The virtual cpu "device" also accepts the ioctls KVM_SET_DEVICE_ATTR, |
| KVM_GET_DEVICE_ATTR, and KVM_HAS_DEVICE_ATTR. The interface uses the same struct |
| kvm_device_attr as other devices, but targets VCPU-wide settings and controls. |
| |
| The groups and attributes per virtual cpu, if any, are architecture specific. |
| |
| 1. GROUP: KVM_ARM_VCPU_PMU_V3_CTRL |
| Architectures: ARM64 |
| |
| 1.1. ATTRIBUTE: KVM_ARM_VCPU_PMU_V3_IRQ |
| Parameters: in kvm_device_attr.addr the address for PMU overflow interrupt is a |
| pointer to an int |
| Returns: -EBUSY: The PMU overflow interrupt is already set |
| -ENXIO: The overflow interrupt not set when attempting to get it |
| -ENODEV: PMUv3 not supported |
| -EINVAL: Invalid PMU overflow interrupt number supplied |
| |
| A value describing the PMUv3 (Performance Monitor Unit v3) overflow interrupt |
| number for this vcpu. This interrupt could be a PPI or SPI, but the interrupt |
| type must be same for each vcpu. As a PPI, the interrupt number is the same for |
| all vcpus, while as an SPI it must be a separate number per vcpu. |
| |
| 1.2 ATTRIBUTE: KVM_ARM_VCPU_PMU_V3_INIT |
| Parameters: no additional parameter in kvm_device_attr.addr |
| Returns: -ENODEV: PMUv3 not supported |
| -ENXIO: PMUv3 not properly configured as required prior to calling this |
| attribute |
| -EBUSY: PMUv3 already initialized |
| |
| Request the initialization of the PMUv3. |
