| /* |
| * linux/arch/arm/mach-sa1100/leds-lart.c |
| * |
| * (C) Erik Mouw (J.A.K.Mouw@its.tudelft.nl), April 21, 2000 |
| * |
| * LART uses the LED as follows: |
| * - GPIO23 is the LED, on if system is not idle |
| * You can use both CONFIG_LEDS_CPU and CONFIG_LEDS_TIMER at the same |
| * time, but in that case the timer events will still dictate the |
| * pace of the LED. |
| */ |
| #include <linux/init.h> |
| |
| #include <mach/hardware.h> |
| #include <asm/leds.h> |
| #include <asm/system.h> |
| |
| #include "leds.h" |
| |
| |
| #define LED_STATE_ENABLED 1 |
| #define LED_STATE_CLAIMED 2 |
| |
| static unsigned int led_state; |
| static unsigned int hw_led_state; |
| |
| #define LED_23 GPIO_GPIO23 |
| #define LED_MASK (LED_23) |
| |
| void lart_leds_event(led_event_t evt) |
| { |
| unsigned long flags; |
| |
| local_irq_save(flags); |
| |
| switch(evt) { |
| case led_start: |
| /* pin 23 is output pin */ |
| GPDR |= LED_23; |
| hw_led_state = LED_MASK; |
| led_state = LED_STATE_ENABLED; |
| break; |
| |
| case led_stop: |
| led_state &= ~LED_STATE_ENABLED; |
| break; |
| |
| case led_claim: |
| led_state |= LED_STATE_CLAIMED; |
| hw_led_state = LED_MASK; |
| break; |
| |
| case led_release: |
| led_state &= ~LED_STATE_CLAIMED; |
| hw_led_state = LED_MASK; |
| break; |
| |
| #ifdef CONFIG_LEDS_TIMER |
| case led_timer: |
| if (!(led_state & LED_STATE_CLAIMED)) |
| hw_led_state ^= LED_23; |
| break; |
| #endif |
| |
| #ifdef CONFIG_LEDS_CPU |
| case led_idle_start: |
| /* The LART people like the LED to be off when the |
| system is idle... */ |
| if (!(led_state & LED_STATE_CLAIMED)) |
| hw_led_state &= ~LED_23; |
| break; |
| |
| case led_idle_end: |
| /* ... and on if the system is not idle */ |
| if (!(led_state & LED_STATE_CLAIMED)) |
| hw_led_state |= LED_23; |
| break; |
| #endif |
| |
| case led_red_on: |
| if (led_state & LED_STATE_CLAIMED) |
| hw_led_state &= ~LED_23; |
| break; |
| |
| case led_red_off: |
| if (led_state & LED_STATE_CLAIMED) |
| hw_led_state |= LED_23; |
| break; |
| |
| default: |
| break; |
| } |
| |
| /* Now set the GPIO state, or nothing will happen at all */ |
| if (led_state & LED_STATE_ENABLED) { |
| GPSR = hw_led_state; |
| GPCR = hw_led_state ^ LED_MASK; |
| } |
| |
| local_irq_restore(flags); |
| } |