blob: 5e343bab9458e430f18f54c1be713a0a7686b593 [file] [log] [blame] [edit]
menu "Remoteproc drivers"
# REMOTEPROC gets selected by whoever wants it
config REMOTEPROC
tristate
depends on HAS_DMA
select CRC32
select FW_LOADER
select VIRTIO
select VIRTUALIZATION
config OMAP_REMOTEPROC
tristate "OMAP remoteproc support"
depends on HAS_DMA
depends on ARCH_OMAP4 || SOC_OMAP5
depends on OMAP_IOMMU
select REMOTEPROC
select MAILBOX
select OMAP2PLUS_MBOX
select RPMSG
help
Say y here to support OMAP's remote processors (dual M3
and DSP on OMAP4) via the remote processor framework.
Currently only supported on OMAP4.
Usually you want to say y here, in order to enable multimedia
use-cases to run on your platform (multimedia codecs are
offloaded to remote DSP processors using this framework).
It's safe to say n here if you're not interested in multimedia
offloading or just want a bare minimum kernel.
config STE_MODEM_RPROC
tristate "STE-Modem remoteproc support"
depends on HAS_DMA
select REMOTEPROC
default n
help
Say y or m here to support STE-Modem shared memory driver.
This can be either built-in or a loadable module.
If unsure say N.
config DA8XX_REMOTEPROC
tristate "DA8xx/OMAP-L13x remoteproc support"
depends on ARCH_DAVINCI_DA8XX
select CMA if MMU
select REMOTEPROC
select RPMSG
help
Say y here to support DA8xx/OMAP-L13x remote processors via the
remote processor framework.
You want to say y here in order to enable AMP
use-cases to run on your platform (multimedia codecs are
offloaded to remote DSP processors using this framework).
This module controls the name of the firmware file that gets
loaded on the DSP. This file must reside in the /lib/firmware
directory. It can be specified via the module parameter
da8xx_fw_name=<filename>, and if not specified will default to
"rproc-dsp-fw".
It's safe to say n here if you're not interested in multimedia
offloading.
endmenu