| # |
| # HIPPI network device configuration |
| # |
| |
| config HIPPI |
| bool "HIPPI driver support (EXPERIMENTAL)" |
| depends on EXPERIMENTAL && INET && PCI |
| ---help--- |
| HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and |
| 1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI |
| can run over copper (25m) or fiber (300m on multi-mode or 10km on |
| single-mode). HIPPI networks are commonly used for clusters and to |
| connect to super computers. If you are connected to a HIPPI network |
| and have a HIPPI network card in your computer that you want to use |
| under Linux, say Y here (you must also remember to enable the driver |
| for your HIPPI card below). Most people will say N here. |
| |
| if HIPPI |
| |
| config ROADRUNNER |
| tristate "Essential RoadRunner HIPPI PCI adapter support (EXPERIMENTAL)" |
| depends on PCI |
| ---help--- |
| Say Y here if this is your PCI HIPPI network card. |
| |
| To compile this driver as a module, choose M here: the module |
| will be called rrunner. If unsure, say N. |
| |
| config ROADRUNNER_LARGE_RINGS |
| bool "Use large TX/RX rings (EXPERIMENTAL)" |
| depends on ROADRUNNER |
| ---help--- |
| If you say Y here, the RoadRunner driver will preallocate up to 2 MB |
| of additional memory to allow for fastest operation, both for |
| transmitting and receiving. This memory cannot be used by any other |
| kernel code or by user space programs. Say Y here only if you have |
| the memory. |
| |
| endif # HIPPI |
