xhci: Recognize USB 3.0 devices as superspeed at powerup
commit 29d214576f936db627ff62afb9ef438eea18bcd2 upstream.
On Intel Panther Point chipset USB 3.0 devices show up as
high-speed devices on powerup, but after an s3 cycle they are
correctly recognized as SuperSpeed. At powerup switch the port
to xHCI so that USB 3.0 devices are correctly recognized.
BugLink: http://bugs.launchpad.net/bugs/1000424
This patch should be backported to kernels as old as 3.0, that contain
commit ID 69e848c2090aebba5698a1620604c7dccb448684 "Intel xhci: Support
EHCI/xHCI port switching."
Signed-off-by: Manoj Iyer <manoj.iyer@canonical.com>
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
Signed-off-by: Ben Hutchings <ben@decadent.org.uk>
diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c
index 833b3c6..e3fcd0a 100644
--- a/drivers/usb/host/pci-quirks.c
+++ b/drivers/usb/host/pci-quirks.c
@@ -863,9 +863,10 @@
/* Disable any BIOS SMIs and clear all SMI events*/
writel(val, base + ext_cap_offset + XHCI_LEGACY_CONTROL_OFFSET);
+hc_init:
if (usb_is_intel_switchable_xhci(pdev))
usb_enable_xhci_ports(pdev);
-hc_init:
+
op_reg_base = base + XHCI_HC_LENGTH(readl(base));
/* Wait for the host controller to be ready before writing any
