| # |
| # Myricom device configuration |
| # |
| |
| config NET_VENDOR_MYRI |
| bool "Myricom devices" |
| default y |
| depends on PCI && INET |
| ---help--- |
| If you have a network (Ethernet) card belonging to this class, say |
| Y and read the Ethernet-HOWTO, available from |
| <http://www.tldp.org/docs.html#howto>. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about Myricom cards. If you say Y, you will be asked for |
| your specific card in the following questions. |
| |
| if NET_VENDOR_MYRI |
| |
| config MYRI10GE |
| tristate "Myricom Myri-10G Ethernet support" |
| depends on PCI && INET |
| select FW_LOADER |
| select CRC32 |
| select INET_LRO |
| ---help--- |
| This driver supports Myricom Myri-10G Dual Protocol interface in |
| Ethernet mode. If the eeprom on your board is not recent enough, |
| you will need a newer firmware image. |
| You may get this image or more information, at: |
| |
| <http://www.myri.com/scs/download-Myri10GE.html> |
| |
| To compile this driver as a module, choose M here. The module |
| will be called myri10ge. |
| |
| config MYRI10GE_DCA |
| bool "Direct Cache Access (DCA) Support" |
| default y |
| depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m) |
| ---help--- |
| Say Y here if you want to use Direct Cache Access (DCA) in the |
| driver. DCA is a method for warming the CPU cache before data |
| is used, with the intent of lessening the impact of cache misses. |
| |
| endif # NET_VENDOR_MYRI |
