| /* |
| * [origin Linux: arch/arm/mach-at91/include/mach/board.h] |
| * |
| * Copyright (C) 2005 HP Labs |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License as published by |
| * the Free Software Foundation; either version 2 of the License, or |
| * (at your option) any later version. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| * |
| * You should have received a copy of the GNU General Public License |
| * along with this program; if not, write to the Free Software |
| * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA |
| */ |
| |
| #ifndef __ASM_ARCH_BOARD_H |
| #define __ASM_ARCH_BOARD_H |
| |
| #include <linux/mtd/mtd.h> |
| |
| void atmel_nand_load_image(void *dest, int size, int pagesize, int blocksize); |
| |
| /* NAND / SmartMedia */ |
| struct atmel_nand_data { |
| void __iomem *ecc_base; |
| u8 enable_pin; /* chip enable */ |
| u8 det_pin; /* card detect */ |
| u8 rdy_pin; /* ready/busy */ |
| u8 ale; /* address line number connected to ALE */ |
| u8 cle; /* address line number connected to CLE */ |
| u8 bus_width_16; /* buswidth is 16 bit */ |
| u8 ecc_mode; /* NAND_ECC_* */ |
| }; |
| |
| void at91_add_device_nand(struct atmel_nand_data *data); |
| |
| /* Ethernet (EMAC & MACB) */ |
| #define AT91SAM_ETHER_MII (0 << 0) |
| #define AT91SAM_ETHER_RMII (1 << 0) |
| #define AT91SAM_ETHER_FORCE_LINK (1 << 1) |
| |
| struct at91_ether_platform_data { |
| unsigned int flags; |
| int phy_addr; |
| }; |
| |
| void at91_add_device_eth(struct at91_ether_platform_data *data); |
| |
| /* SDRAM */ |
| void at91_add_device_sdram(u32 size); |
| |
| /* Serial */ |
| #define ATMEL_UART_CTS 0x01 |
| #define ATMEL_UART_RTS 0x02 |
| #define ATMEL_UART_DSR 0x04 |
| #define ATMEL_UART_DTR 0x08 |
| #define ATMEL_UART_DCD 0x10 |
| #define ATMEL_UART_RI 0x20 |
| |
| void at91_register_uart(unsigned id, unsigned pins); |
| #endif |