#include <Copyright.h>
/********************************************************************************
* pirl.c
*
* DESCRIPTION:
*       Setup PIRL buckets
*
* DEPENDENCIES:   None.
*
* FILE REVISION NUMBER:
*
*******************************************************************************/
#include "msSample.h"


/*
 *  This setup function configures the Port 0 of Marvell SOHO Switch Device with
 *    capability of PIRL to be :
 *
 *    1) Ingress Rate    : 128Kbps (128K bit per sec)
 *    2) Discarded frame : Do not account discarded frame due to queue congestion
 *    3) Filtered frame  : Account filtered frame
 *    4) Limit action    : Drop packets when the incoming rate exceeds the limit
 *    5) Rate type       : Rate is based on Traffic type
 *    6) Traffic type    : ARP, MGMT, Multicast, Broadcast, and Unicast frames are
 *                         tracked as part of the rate resource calculation.
 *    7) Byte counted    : Account only Layer 3 bytes (IP header and payload)
 *
 *    Notes: This sample uses IRL Unit 0. The available number of IRL Units are
 *    various depending on the device. Please refer to the datasheet for detailed
 *    information.
 *
 *    Notes: Port 0 will be blocked while programming PIRL.
*/

GT_STATUS samplePIRLSetup(GT_QD_DEV *dev)
{
    GT_STATUS status;
    GT_PIRL_DATA pirlData;
    GT_U32        irlUnit;
    GT_LPORT     port;

    /* change Current Timer Update Interval */
    status = gpirlSetCurTimeUpInt(dev,4);
    switch (status)
    {
        case GT_OK:
            break;
        case GT_NOT_SUPPORTED:
            MSG_PRINT(("Device is not supporting PIRL.\n"));
            return status;
        default:
            MSG_PRINT(("Failure to configure device.\n"));
            return status;
    }

    irlUnit = 0;
    port = 0;

    pirlData.ingressRate         = 128;
    pirlData.accountQConf         = GT_FALSE;
    pirlData.accountFiltered    = GT_TRUE;
    pirlData.ebsLimitAction        = ESB_LIMIT_ACTION_DROP;
    pirlData.bktRateType        = BUCKET_TYPE_TRAFFIC_BASED;
    pirlData.bktTypeMask        = BUCKET_TRAFFIC_BROADCAST |
                                  BUCKET_TRAFFIC_MULTICAST |
                                  BUCKET_TRAFFIC_UNICAST   |
                                  BUCKET_TRAFFIC_MGMT_FRAME|
                                  BUCKET_TRAFFIC_ARP;

    pirlData.byteTobeCounted    = GT_PIRL_COUNT_ALL_LAYER3;

    status = gpirlActivate(dev,irlUnit,(1<<port),&pirlData);

    switch (status)
    {
        case GT_OK:
            MSG_PRINT(("IRL Unit 0 is activated.\n"));
            break;
        case GT_BAD_PARAM:
            MSG_PRINT(("Invalid parameters are given.\n"));
            break;
        case GT_NOT_SUPPORTED:
            MSG_PRINT(("Device is not supporting PIRL.\n"));
            break;
        default:
            MSG_PRINT(("Failure to configure device.\n"));
            break;
    }

    return status;
}