| /* |
| * atmel platform data |
| * |
| * GPL v2 Only |
| */ |
| |
| #ifndef __ATMEL_H__ |
| #define __ATMEL_H__ |
| |
| #include <linux/mtd/nand.h> |
| #include <linux/mtd/partitions.h> |
| #include <linux/serial.h> |
| |
| /* Compact Flash */ |
| struct at91_cf_data { |
| int irq_pin; /* I/O IRQ */ |
| int det_pin; /* Card detect */ |
| int vcc_pin; /* power switching */ |
| int rst_pin; /* card reset */ |
| u8 chipselect; /* EBI Chip Select number */ |
| u8 flags; |
| #define AT91_CF_TRUE_IDE 0x01 |
| #define AT91_IDE_SWAP_A0_A2 0x02 |
| }; |
| |
| /* NAND / SmartMedia */ |
| struct atmel_nand_data { |
| int enable_pin; /* chip enable */ |
| int det_pin; /* card detect */ |
| int rdy_pin; /* ready/busy */ |
| u8 rdy_pin_active_low; /* rdy_pin value is inverted */ |
| u8 ale; /* address line number connected to ALE */ |
| u8 cle; /* address line number connected to CLE */ |
| u8 bus_width_16; /* buswidth is 16 bit */ |
| u8 ecc_mode; /* ecc mode */ |
| u8 on_flash_bbt; /* bbt on flash */ |
| struct mtd_partition *parts; |
| unsigned int num_parts; |
| bool has_dma; /* support dma transfer */ |
| |
| /* default is false, only for at32ap7000 chip is true */ |
| bool need_reset_workaround; |
| }; |
| |
| /* Serial */ |
| struct atmel_uart_data { |
| int num; /* port num */ |
| short use_dma_tx; /* use transmit DMA? */ |
| short use_dma_rx; /* use receive DMA? */ |
| void __iomem *regs; /* virt. base address, if any */ |
| struct serial_rs485 rs485; /* rs485 settings */ |
| }; |
| |
| /* FIXME: this needs a better location, but gets stuff building again */ |
| extern int at91_suspend_entering_slow_clock(void); |
| |
| #endif /* __ATMEL_H__ */ |
