#
# configuration for diagnostic scripts
#

# defaults, if not overridden
iperf_server=192.168.1.100

# these can be set on the boot line or the environment
diag_essid="${diag_essid:-$(kernopt diag_essid)}"
diag_iperf_server="${diag_iperf_server:-$(kernopt diag_iperf_server)}"

#
# general configs here
#

dram_memory=10M		# how much memory to test

wifi_essid="${diag_essid:-factory}"

wired_lan=lan0
wired_wan=wan0

# iperf_server_* can be overriden by environment
iperf_server_lan0="${iperf_server_lan0:-${diag_iperf_server:-$iperf_server}}"
iperf_min_lan0=10		# MBytes/sec

iperf_server_wan0="${iperf_server_wan0:-${diag_iperf_server:-$iperf_server}}"
iperf_min_wan0=10		# MBytes/sec

iperf_server_weth0="${iperf_server_weth0:-${diag_iperf_server:-$iperf_server}}"
iperf_min_weth0=10		# MBytes/sec

iperf_server_weth1="${iperf_server_weth1:-${diag_iperf_server:-$iperf_server}}"
iperf_min_weth1=10		# MBytes/sec

disk_badblock_count=3000000	# number of blocks to check (large is slow)
disk_min_mibps=90		# 90MiB/s read is nice, 120 is great

usb_min_bps=36000000		# 36 MB/s seen on usb3.0 drive
usb_min_bps=1000000		# lower until we get a good value

fan_temp1_min=29000		# 29-45 degrees celcius, just a guideline for now
fan_temp1_max=45000
fan_temp2_min=29000
fan_temp2_max=45000

fan_max_rpm=5000

has_wifi=1

#
# platform specific configs follow
#
PLATFORM_NAME=$(hnvram -qr PLATFORM_NAME || true)
case "$PLATFORM_NAME" in
  GFHD100)
    ;;
  GFMS100)
    ;;
  GFRG200)
    ;;
  GFRG210)
    ;;
  GFRG250)
    ;;
  GFSC100)
    has_wifi=0
    ;;
  *)
    echo "$0: WARNING: unknown platform '$PLATFORM_NAME', using defaults" 1>&2
    ;;
esac