drivers/mci/Kconfig

menuconfig MCI
	bool "MCI drivers                   "
	select ATA
	select ATA_DISK
	help
	  Add support for MCI drivers, used to handle MMC and SD cards

if MCI

comment "--- Feature list ---"

config MCI_STARTUP
	bool "Probe on system start"
	help
	  Say 'y' here if the MCI framework should probe for attached MCI cards
	  on system start up. This is required if the card carries barebox's
	  environment (for example on systems where the MCI card is the sole
	  bootmedia). Otherwise probing run on demand with "mci*.probe=1"

config MCI_INFO
	bool "MCI Info"
	depends on CMD_DEVINFO
	default y
	help
	  This entry adds more info about the attached MCI card, when the
	  'devinfo' command is used on the mci device.

config MCI_WRITE
	bool "Support writing to MCI cards"
	default y
	select ATA_WRITE

comment "--- MCI host drivers ---"

config MCI_MXS
	bool "i.MX23/i.MX28"
	depends on ARCH_MXS
	help
	  Enable this entry to add support to read and write SD cards on a
	  i.MX23/i.MX28 based system.

config MCI_S3C
	bool "S3C"
	depends on ARCH_S3C24xx
	help
	  Enable this entry to add support to read and write SD cards on a
	  Samsung S3C24xx based system.

config MCI_IMX
	bool "i.MX"
	depends on ARCH_IMX27 || ARCH_IMX31
	help
	  Enable this entry to add support to read and write SD cards on a
	  Freescale i.MX based system.

config MCI_IMX_ESDHC
	bool "i.MX esdhc"
	depends on ARCH_IMX25 || ARCH_IMX35 || ARCH_IMX51
	help
	  Enable this entry to add support to read and write SD cards on a
	  Freescale i.MX25/35/51 based system.

config MCI_IMX_ESDHC_PIO
	bool "use PIO mode"
	depends on MCI_IMX_ESDHC
	help
	  mostly useful for debugging. Normally you should use DMA.

config MCI_OMAP_HSMMC
	bool "OMAP HSMMC"
	depends on ARCH_OMAP4 || ARCH_OMAP3
	help
	  Enable this entry to add support to read and write SD cards on a
	  OMAP4 based system.

endif