#include <sizes.h>

#ifndef __CONFIG_H
#define __CONFIG_H

#define CONFIG_LBA48

#define DDR_SIZE	SZ_512M

#define CFG_I2C_EEPROM0_ADDR	0x50
#define CFG_I2C_EEPROM1_ADDR	0x54
#define I2C_EEPROM_PAGE_SZ	128
#define I2C_EEPROM_SIZE		(I2C_EEPROM_AT24C512B_SZ + I2C_EEPROM_24FC512_SZ)
#define I2C_EEPROM_AT24C512B_SZ	(64 * 1024)
#define I2C_EEPROM_24FC512_SZ	(64 * 1024)

#define NOR_FLASH_SIZE          128 * 1024 * 1024

//May need to change the PHY addresses
#define EMAC0_PHY_ADDR  4
#define EMAC1_PHY_ADDR  5
#define EMAC0_FLAGS	0
#define EMAC1_FLAGS	0
#define EMAC2_FLAGS	0

//int c2000_eth_board_init(void);

#define EXP_CS0_BASE_VAL	0x0
#define EXP_CS0_SEG_SIZE_VAL	0x7FFF
#define EXP_CS0_SEG_END_VAL	(EXP_CS0_BASE_VAL + EXP_CS0_SEG_SIZE_VAL)

#define EXP_CS1_BASE_VAL	(EXP_CS0_SEG_END_VAL + 1)
#define EXP_CS1_SEG_SIZE_VAL	0xFF
#define EXP_CS1_SEG_END_VAL	(EXP_CS1_BASE_VAL + EXP_CS1_SEG_SIZE_VAL)

#define EXP_CS2_BASE_VAL	(EXP_CS1_SEG_END_VAL + 1)
#define EXP_CS2_SEG_SIZE_VAL	0xFF
#define EXP_CS2_SEG_END_VAL	(EXP_CS2_BASE_VAL + EXP_CS2_SEG_SIZE_VAL)

#define EXP_CS3_BASE_VAL	(EXP_CS2_SEG_END_VAL + 1)
#define EXP_CS3_SEG_SIZE_VAL	0xFF
#define EXP_CS3_SEG_END_VAL	(EXP_CS3_BASE_VAL + EXP_CS3_SEG_SIZE_VAL)

#define EXP_CS4_BASE_VAL	(EXP_CS3_SEG_END_VAL + 1)
#define EXP_CS4_SEG_SIZE_VAL	0xFF
#define EXP_CS4_SEG_END_VAL	(EXP_CS4_BASE_VAL + EXP_CS4_SEG_SIZE_VAL)

#define SHIFT_4K_MUL	12

#define COMCERTO_EXP_CS4_BASE_ADDR	(COMCERTO_AXI_EXP_BASE + (EXP_CS4_BASE_VAL << SHIFT_4K_MUL))

/*SPI NOR Flash CS:0*/
#define SPI_FLASH_SIZE  (16 * 1024 * 1024) /* 16 MB */
#define SPI_FLASH_SECTOR_64KB     (64 * 1024)
#define SPI_FLASH_SECTOR_256KB    (256 * 1024)
#define SPI_FLASH_NOR_PAGE_SIZE   256 /* Bytes */
#define SPI_FLASH_SECTOR_SIZE     SPI_FLASH_SECTOR_64KB
#define SPI_FLASH_NUM_SECTORS     (SPI_FLASH_SIZE/SPI_FLASH_SECTOR_SIZE)
#define SPI_FLASH_NUM_PAGES_PER_SEC       (SPI_FLASH_SECTOR_SIZE/SPI_FLASH_NOR_PAGE_SIZE)

/*Fast SPI NOR Flash CS:0*/
#define FAST_SPI_FLASH_SIZE		(16 * 1024 * 1024) /* 16 MB */
#define	FAST_SPI_FLASH_SECTOR_64KB	(64 * 1024)
#define FAST_SPI_FLASH_PAGE_SIZE	256 /* Bytes */
#define FAST_SPI_FLASH_SECTOR_SIZE	FAST_SPI_FLASH_SECTOR_64KB

//In case MLC NAND is used on the Asic Board, comment this out
//#define CONFIG_NAND_TYPE_SLC

#if defined (CONFIG_NAND_TYPE_SLC)
#define COMCERTO_NAND_FLASH_SIZE	(512UL * 1024UL * 1024UL)
#else
#define COMCERTO_NAND_FLASH_SIZE	(2UL * 1024UL * 1024UL * 1024UL)
#endif

#endif  /* __CONFIG_H */