blob: 523341a0e1131a3e7b51878632b4040fb3a428c9 [file] [log] [blame]
* Freescale (Enhanced) Configurable Serial Peripheral Interface
(CSPI/eCSPI) for i.MX
Required properties:
- compatible :
- "fsl,imx1-cspi" for SPI compatible with the one integrated on i.MX1
- "fsl,imx21-cspi" for SPI compatible with the one integrated on i.MX21
- "fsl,imx27-cspi" for SPI compatible with the one integrated on i.MX27
- "fsl,imx31-cspi" for SPI compatible with the one integrated on i.MX31
- "fsl,imx35-cspi" for SPI compatible with the one integrated on i.MX35
- "fsl,imx51-ecspi" for SPI compatible with the one integrated on i.MX51
- reg : Offset and length of the register set for the device
- interrupts : Should contain CSPI/eCSPI interrupt
- fsl,spi-num-chipselects : Contains the number of the chipselect
- cs-gpios : Specifies the gpio pins to be used for chipselects.
- clocks : Clock specifiers for both ipg and per clocks.
- clock-names : Clock names should include both "ipg" and "per"
See the clock consumer binding,
Documentation/devicetree/bindings/clock/clock-bindings.txt
- dmas: DMA specifiers for tx and rx dma. See the DMA client binding,
Documentation/devicetree/bindings/dma/dma.txt
- dma-names: DMA request names should include "tx" and "rx" if present.
Example:
ecspi@70010000 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "fsl,imx51-ecspi";
reg = <0x70010000 0x4000>;
interrupts = <36>;
fsl,spi-num-chipselects = <2>;
cs-gpios = <&gpio3 24 0>, /* GPIO3_24 */
<&gpio3 25 0>; /* GPIO3_25 */
dmas = <&sdma 3 7 1>, <&sdma 4 7 2>;
dma-names = "rx", "tx";
};