blob: 0f04ffe9c5a87c2afb4f90b02d75b86b70fd722b [file] [log] [blame]
/*
* at91sam926x_time.c - Periodic Interval Timer (PIT) for at91sam926x
*
* Copyright (C) 2005-2006 M. Amine SAYA, ATMEL Rousset, France
* Revision 2005 M. Nicolas Diremdjian, ATMEL Rousset, France
* Converted to ClockSource/ClockEvents by David Brownell.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/interrupt.h>
#include <linux/irq.h>
#include <linux/kernel.h>
#include <linux/clk.h>
#include <linux/clockchips.h>
#include <linux/of.h>
#include <linux/of_address.h>
#include <linux/of_irq.h>
#include <asm/mach/time.h>
#define AT91_PIT_MR 0x00 /* Mode Register */
#define AT91_PIT_PITIEN (1 << 25) /* Timer Interrupt Enable */
#define AT91_PIT_PITEN (1 << 24) /* Timer Enabled */
#define AT91_PIT_PIV (0xfffff) /* Periodic Interval Value */
#define AT91_PIT_SR 0x04 /* Status Register */
#define AT91_PIT_PITS (1 << 0) /* Timer Status */
#define AT91_PIT_PIVR 0x08 /* Periodic Interval Value Register */
#define AT91_PIT_PIIR 0x0c /* Periodic Interval Image Register */
#define AT91_PIT_PICNT (0xfff << 20) /* Interval Counter */
#define AT91_PIT_CPIV (0xfffff) /* Inverval Value */
#define PIT_CPIV(x) ((x) & AT91_PIT_CPIV)
#define PIT_PICNT(x) (((x) & AT91_PIT_PICNT) >> 20)
static u32 pit_cycle; /* write-once */
static u32 pit_cnt; /* access only w/system irq blocked */
static void __iomem *pit_base_addr __read_mostly;
static struct clk *mck;
static inline unsigned int pit_read(unsigned int reg_offset)
{
return __raw_readl(pit_base_addr + reg_offset);
}
static inline void pit_write(unsigned int reg_offset, unsigned long value)
{
__raw_writel(value, pit_base_addr + reg_offset);
}
/*
* Clocksource: just a monotonic counter of MCK/16 cycles.
* We don't care whether or not PIT irqs are enabled.
*/
static cycle_t read_pit_clk(struct clocksource *cs)
{
unsigned long flags;
u32 elapsed;
u32 t;
raw_local_irq_save(flags);
elapsed = pit_cnt;
t = pit_read(AT91_PIT_PIIR);
raw_local_irq_restore(flags);
elapsed += PIT_PICNT(t) * pit_cycle;
elapsed += PIT_CPIV(t);
return elapsed;
}
static struct clocksource pit_clk = {
.name = "pit",
.rating = 175,
.read = read_pit_clk,
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
/*
* Clockevent device: interrupts every 1/HZ (== pit_cycles * MCK/16)
*/
static void
pit_clkevt_mode(enum clock_event_mode mode, struct clock_event_device *dev)
{
switch (mode) {
case CLOCK_EVT_MODE_PERIODIC:
/* update clocksource counter */
pit_cnt += pit_cycle * PIT_PICNT(pit_read(AT91_PIT_PIVR));
pit_write(AT91_PIT_MR, (pit_cycle - 1) | AT91_PIT_PITEN
| AT91_PIT_PITIEN);
break;
case CLOCK_EVT_MODE_ONESHOT:
BUG();
/* FALLTHROUGH */
case CLOCK_EVT_MODE_SHUTDOWN:
case CLOCK_EVT_MODE_UNUSED:
/* disable irq, leaving the clocksource active */
pit_write(AT91_PIT_MR, (pit_cycle - 1) | AT91_PIT_PITEN);
break;
case CLOCK_EVT_MODE_RESUME:
break;
}
}
static void at91sam926x_pit_suspend(struct clock_event_device *cedev)
{
/* Disable timer */
pit_write(AT91_PIT_MR, 0);
}
static void at91sam926x_pit_reset(void)
{
/* Disable timer and irqs */
pit_write(AT91_PIT_MR, 0);
/* Clear any pending interrupts, wait for PIT to stop counting */
while (PIT_CPIV(pit_read(AT91_PIT_PIVR)) != 0)
cpu_relax();
/* Start PIT but don't enable IRQ */
pit_write(AT91_PIT_MR, (pit_cycle - 1) | AT91_PIT_PITEN);
}
static void at91sam926x_pit_resume(struct clock_event_device *cedev)
{
at91sam926x_pit_reset();
}
static struct clock_event_device pit_clkevt = {
.name = "pit",
.features = CLOCK_EVT_FEAT_PERIODIC,
.shift = 32,
.rating = 100,
.set_mode = pit_clkevt_mode,
.suspend = at91sam926x_pit_suspend,
.resume = at91sam926x_pit_resume,
};
/*
* IRQ handler for the timer.
*/
static irqreturn_t at91sam926x_pit_interrupt(int irq, void *dev_id)
{
/*
* irqs should be disabled here, but as the irq is shared they are only
* guaranteed to be off if the timer irq is registered first.
*/
WARN_ON_ONCE(!irqs_disabled());
/* The PIT interrupt may be disabled, and is shared */
if ((pit_clkevt.mode == CLOCK_EVT_MODE_PERIODIC)
&& (pit_read(AT91_PIT_SR) & AT91_PIT_PITS)) {
unsigned nr_ticks;
/* Get number of ticks performed before irq, and ack it */
nr_ticks = PIT_PICNT(pit_read(AT91_PIT_PIVR));
do {
pit_cnt += pit_cycle;
pit_clkevt.event_handler(&pit_clkevt);
nr_ticks--;
} while (nr_ticks);
return IRQ_HANDLED;
}
return IRQ_NONE;
}
static struct irqaction at91sam926x_pit_irq = {
.name = "at91_tick",
.flags = IRQF_SHARED | IRQF_TIMER | IRQF_IRQPOLL,
.handler = at91sam926x_pit_interrupt,
.irq = NR_IRQS_LEGACY + AT91_ID_SYS,
};
#ifdef CONFIG_OF
static struct of_device_id pit_timer_ids[] = {
{ .compatible = "atmel,at91sam9260-pit" },
{ /* sentinel */ }
};
static int __init of_at91sam926x_pit_init(void)
{
struct device_node *np;
int ret;
np = of_find_matching_node(NULL, pit_timer_ids);
if (!np)
goto err;
pit_base_addr = of_iomap(np, 0);
if (!pit_base_addr)
goto node_err;
mck = of_clk_get(np, 0);
/* Get the interrupts property */
ret = irq_of_parse_and_map(np, 0);
if (!ret) {
pr_crit("AT91: PIT: Unable to get IRQ from DT\n");
if (!IS_ERR(mck))
clk_put(mck);
goto ioremap_err;
}
at91sam926x_pit_irq.irq = ret;
of_node_put(np);
return 0;
ioremap_err:
iounmap(pit_base_addr);
node_err:
of_node_put(np);
err:
return -EINVAL;
}
#else
static int __init of_at91sam926x_pit_init(void)
{
return -EINVAL;
}
#endif
/*
* Set up both clocksource and clockevent support.
*/
void __init at91sam926x_pit_init(void)
{
unsigned long pit_rate;
unsigned bits;
int ret;
mck = ERR_PTR(-ENOENT);
/* For device tree enabled device: initialize here */
of_at91sam926x_pit_init();
/*
* Use our actual MCK to figure out how many MCK/16 ticks per
* 1/HZ period (instead of a compile-time constant LATCH).
*/
if (IS_ERR(mck))
mck = clk_get(NULL, "mck");
if (IS_ERR(mck))
panic("AT91: PIT: Unable to get mck clk\n");
pit_rate = clk_get_rate(mck) / 16;
pit_cycle = (pit_rate + HZ/2) / HZ;
WARN_ON(((pit_cycle - 1) & ~AT91_PIT_PIV) != 0);
/* Initialize and enable the timer */
at91sam926x_pit_reset();
/*
* Register clocksource. The high order bits of PIV are unused,
* so this isn't a 32-bit counter unless we get clockevent irqs.
*/
bits = 12 /* PICNT */ + ilog2(pit_cycle) /* PIV */;
pit_clk.mask = CLOCKSOURCE_MASK(bits);
clocksource_register_hz(&pit_clk, pit_rate);
/* Set up irq handler */
ret = setup_irq(at91sam926x_pit_irq.irq, &at91sam926x_pit_irq);
if (ret)
pr_crit("AT91: PIT: Unable to setup IRQ\n");
/* Set up and register clockevents */
pit_clkevt.mult = div_sc(pit_rate, NSEC_PER_SEC, pit_clkevt.shift);
pit_clkevt.cpumask = cpumask_of(0);
clockevents_register_device(&pit_clkevt);
}
void __init at91sam926x_ioremap_pit(u32 addr)
{
#if defined(CONFIG_OF)
struct device_node *np =
of_find_matching_node(NULL, pit_timer_ids);
if (np) {
of_node_put(np);
return;
}
#endif
pit_base_addr = ioremap(addr, 16);
if (!pit_base_addr)
panic("Impossible to ioremap PIT\n");
}